When we use the soap dispenser at home, we may sometimes encounter some small faults. How can we solve these situations? Next, teach you a few tricks
If the soap dispenser has been idle for a period of time, some soap may condense in the soap dispenser. If the amount of soap is small, just stir it with warm water. This will restore the soap to liquid. If the above method is not feasible, put the condensed soap Remove, add warm water, and use the soap dispenser several times until the warm water runs out of the soap dispenser, which will clean the entire soap dispenser.

Please note that dust and impurities in the soap will block the liquid outlet. If you notice that the soap in the inner bottle has deteriorated, please replace the soap.

If the soap is too thick, it may cause the soap dispenser to run out of liquid. In order to dilute the soap, add a little water and stir it before use.

When using the product for the first time, add clean water to discharge the vacuum inside. When adding soap liquid, the inner bottle and pump head may contain some clean water when using the product for the first time. This is not a quality problem of the product, but the product leaves the factory. left over from previous inspections.

With the improvement of the technology of soap dispensers, the reasonable capacity design of soap dispensers on the market can make the soap liquid reasonably use up within the shelf life. Avoid the occurrence of bad appeals.